Neck face artpaper mache face5/22/2023 ![]() Following the same steps as earlier, apply a second layer and let it dry completely. Once the first layer has completely dried, remove the bowl of paste from the fridge and mix it with a spoon until it’s smooth again. The next day, however, it was rainy and cool and damp, so I had to work indoors.and it took the next layer all day to dry. My first layer dried in just a couple hours because I placed it outside, in the sun, on a hot day. ![]() ![]() It’s okay that it won’t completely conform to all the curves.just make sure it’s not pulled tight over areas of the face that are depressed or sunken, or you won’t be able to press the paper along these forms.īut DON'T apply all the way around (Photo by Viana Boenzli)ĭry time will depend on a lot of factors, but particularly warmth and humidity. Gently press the cling along the curves of the face as much as possible. In order to avoid the paper mache sticking to the styrofoam head, cover the entire head with a layer of plastic cling wrap. Nooooooo! But my brain turned to recovery mode.How can I salvage what I have left and still make it into something really cool and spooky for Halloween? Keep reading to find out… □ Materials After making the cut up the center of the back of the head, I gently tried to coerce the dried paper off the head, but it began ripping here and ripping there. The plan was to apply the paper mache all over the head, then cut a seam up the back and gently peel it off the head form. Taking the head form into the kitchen, I began cutting up strips of newspaper and mixing up a witches’ brew of paste, ready to dip my fingers into this messy yet fun project! The gentle curves of the nose and cheekbones, and the subtle hint of closed eyes was just what I was looking for to make a paper mache face for Halloween! So one day, while looking through my craft room, I came across a styrofoam head form that I’ve often used to display my crocheted hats and scarves for photo shoots. Viana & Erich.uh, I mean Jack Skellingtonīut I wanted to try something different, more detailed, with more curves.
0 Comments
Leave a Reply. |